In this application, two dual fiber switches are connected via single-fiber. Typically BIDI single-fiber uses 1310nm and 1550nm wavelengths over the same fiber strand in opposite directions. Single-fiber is single-mode and operates with bi-directional wavelengths, often referred to as BIDI. In some networks we need to convert between duplex fiber and single-fiber, depending on the type of equipment and the fiber installed in the facility. Multimode fiber equipment is in a campus building and single mode fiber is used between buildingsĪ fiber-to-fiber media converter can extend a multimode fiber network across single mode fiber up to 160km.ĭual (Duplex) Fiber to Single-Fiber Media Converter.A building has multimode fiber equipment, while the connection to the service provider is single mode fiber.Legacy networking equipment uses multimode fiber, and connectivity is required to single mode fiber equipment.Multimode to Single-mode Fiber Media ConverterĮnterprise networks often require conversion from multimode fiber to single mode fiber in these cases: In this example, a pair of RS-232 converters provides the serial connection between a PC and Terminal Server. They can automatically detect the signal baud rate of the connected Full-Duplex serial device, and support point-to-point and multi-point configurations. Serial-to-fiber converters provide fiber extension for serial protocol copper connections. In this application, a pair of T1/E1 media converters is used to extend the demarcation point (hand-off from the Service Provider) to another tenant building with fiber. T1/E1 (T3/E3) converters operate in pairs extending distances of TDM circuits over fiber. Fiber links can be extended up to 120km using single-mode fiber. T1/E1 (T3/E3) TDM over Fiber Media Converter An Ethernet switch (D) is connected directly via fiber to the media converter module at the network core.Another media converter connects a PC UTP port in a fiber-to-desktop application (C).A UTP workgroup switch (B) is connected via fiber to the network core with a standalone media converter.In this application example, Ethernet copper to fiber media converters are installed in a redundant power chassis for high-density fiber distribution from the network core (A). A pair of copper-to-fiber media converters is used to connect two copper switches via fiber.Įthernet Copper to Fiber Media Converter for High-Density Fiber Distribution This application shows how to use fiber media converters to provide seamless integration of different Ethernet cabling media. Industrial Fiber Media Converter with DIN-RAIL mounting
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |